Trot Mooring

Trot Moorings are arranged in a line and the boats are tethered fore and aft. Because the boats do not move around it enables many more boats to be moored in the same area. As the moorings are tied together, even when the trot is unoccupied, such arrangements restrict the use of the river for sailing. Trots can be single or double – double being two boats side by side with fendering on each berth. 

  • Vessels on swinging & trot moorings must be secured in the following manner

    Swinging Moorings   Anchor chain shackled on to the ring on top of the buoy with shackle pin moused - please do not use stainless steel wire mousing as this causes corrosion;  also a rope preventer secured to the buoy with a round turn and bowline or half hitches and then to another secure point on the vessel.

    Fore & Aft Trot Moorings  As for swinging berths, but in addition two ropes secured aft.  When doubled-up breast lines and springs must be used to the other vessel and adequate fenders shipped.  The weight of the craft must be taken by its own lines and not by the bridle.

    Link Line  On trot berths a link line between the mooring buoys must  be provided by the berth holder whenever the vessel is away from the berth.  This includes winter  periods. The link line should be of adequate size and strength and no longer than the total of the vessels and their mooring ropes so as to maintain the berth in its normal state.

    •   Additional warps must be left accessibly on board for use in emergencies.  Lines should NOT be rove through buoy rings as this causes chafing.
    •  All covers are to be close fitting.  Large spray hoods or similar open covers cause windage and place added strain on the mooring and must be stowed when the vessel is on the mooring.
    • All propellers on exposed outboards must be covered by a bucket or basket.